 |
At first,
use blower to fill air to about 80% toward the bigger ventilation.
(Freezing wind is necessary.)
use blower to fill air to about 80% toward the bigger ventilation.
(Freezing wind is necessary.)
 |
And then, use the pump attached to fill air to the smaller ventilation until it is full.
 |
At first, use soap solution to spray over the hole ,
and so the area where the hole exists will begin to bubble.
and so the area where the hole exists will begin to bubble.
1. Don't ever pump into any inflammable gas but only air. (for ex. hydrogen)
2. Don't use any chemical cleansers to wash but only soap & water.
3. Please keep away from sharp objects. (In case of being stabbed into)
4. Please avoid placing at location which is over hot or cold.
5. Please don't over-fill the product from causing its tears.
And more...
 |
And then wipe off the soap solution ; administer glue to the hole.
 |
Finally, use the slice piece to stick to the damaged ; the job is done.
 |
 |
 |
 |
 |